ASIs Tiger Piezo DAC card enables the tiger system to control two piezo controller via two 0-10V signals. The Tiger system can support multiple Piezo DAC cards, these card can then be controlled thru RS-232 serial commands or thru Knobs.
This card has been supplanted by the TGGALVO / TGDAC4 card for tiger.
—-
NOTE: The equivalent of this on MS2000/WizKid systems is the single 0-10V analog output available with “PZ” firmware. The PZ firmware differs from ASI's normal “Z” or “ADEPT” firmware in that it does not directly control a motor or piezo stack, but instead provides an analog voltage for a thrid-party piezo driver. The expected piezo range is set per normal using the CCA X command, like in ADEPT builds.