Command:PZINFO

MS2000 or RM2000 syntax

Format	PZINFO

Tiger syntax

Format	[addr#]PZINFO
Type	Card-Addressed

PZINFO is a diagnostic command. ASI reserves the right to change the format of the PZINFO command at any point as more diagnostic features are found to be useful.

MicroMirror Example on Tiger

3PZINFO
Hdwr REV.E 
V0 :24.3 V
HV :143.5 V
V1 :63.7 V
V2 :63.2 V
V3 :63.2 V
V4 :64.9 V
V5 :64.3 V
V6 :65.4 V
I2C Check> DAC[OK] OSC1[OK] OSC2[OK] EEPROM[OK]
Mode> A[IN] B[IN] C[IN] D[IN]

Piezo Example on Tiger

1PZINFO
Voltages @ Pos1>
HV   : 147 V
Sout : 4 V
Pzout: 65 V
I2C Check> DAC[OK] SWITCH[OK] DigPot[OK] 
ADEPT Rev 0
DigPot> Sgoffset: 110 Gain: 96 
Closed Loop
TG1000 IN
HV ENABLE 
FAST MODE  
SG Offset [OK]

Piezo Example on MS2000

PZINFO
Voltages @ Pos1>
HV   : 147 V
Sout : 4 V
Pzout: 65 V
I2C Check> DAC[OK] SWITCH[OK] DigPot[OK] 
ADEPT Rev 0
DigPot> Sgoffset: 110 Gain: 96 
Closed Loop
TG1000 IN
HV ENABLE 
FAST MODE  
SG Offset [OK]

PMT example on TGPMT

if TGPMT card address is 7.

7pzinfo
Hdwr REV.0 
V0 :24.0 V
V1 :15.0 V
Avg: 2 
I2C FRAM: OK 
PMT0> Gain:   0 , ADC:   13 , BG:    0 , Status: ENABLED 
PMT1> Gain:   0 , ADC:   13 , BG:    0 , Status: ENABLED 
<LF>