====== Tiger Piezo DAC Card ======
 

ASIs Tiger Piezo DAC card enables the tiger system to control two piezo controller via two 0-10V signals. The Tiger system can support multiple Piezo DAC cards, these card can then be controlled thru RS-232 serial commands or thru Knobs. 

This card has been supplanted by the [[tggalvo|TGGALVO / TGDAC4]] card for tiger.
  
  
----
<WRAP center round info 60%>
NOTE: The equivalent of this on MS2000/WizKid systems is the single 0-10V analog output available with "PZ" firmware. The PZ firmware differs from ASI's normal "Z" or "ADEPT" firmware in that it does not directly control a motor or piezo stack, but instead provides an analog voltage for a thrid-party piezo driver. The expected piezo range is set per normal using the [[commands:customa|CCA X]] command, like in ADEPT builds.
</WRAP>

===== Electrical Characteristics =====
 
  * Voltage Range: 0-10Volts
  * Output Current: 50mA / -80mA

{{tag>manual tiger piezo 0-10v}}