====== Command:SAVESET (SS) ======

--> MS2000 or RM2000 syntax^ 

^Shortcut  |SS| 
^Format  |SAVESET [X][Y][Z] |

<--

--> Tiger syntax^

^Shortcut  |SS| 
^Format  |[addr#]SAVESET [X][Y][Z] |
^Type    |Card-Addressed  |

<--

''SAVESET'' allows the user to save current parameters settings to Flash memory. \\
''SAVESET Z'', saves settings to flash memory \\
''SAVESET Y'', restores previously saved settings after a ''SAVESET X'' \\
''SAVESET X'', will reload factory defaults upon next power-up \\

==Reply==
Upon the start of execution of this command, the controller will reply with a  <wrap reply> : </wrap>.

When the execution is complete, an  <wrap reply> A </wrap> will follow the colon.

**Note 1:**  During the time interval between the <wrap reply> : </wrap> and the <wrap reply> A </wrap>, no serial or manual moves should be given.

**Note 2:**  In MS2000 Versions 6.1u and later (see ''VERSION'' command), limit settings (see ''SETLOW'' and ''SETUP'') are saved if and only if the ''SAVEPOS'' command is issued after the command ''SAVESET Z''.


== Example ==

--> MS2000 example ^

<asi> $ SS Z		
:A</asi>
Save the current settings to flash memory.
<--

--> Tiger example ^

<asi> $ 1SS Z		
:A</asi>
Save the Tiger Card at Card Address 1's current settings to flash memory.
<--

{{tag>commands tiger ms2000}}