====== Command:PZINFO ======

--> MS2000 or RM2000 syntax ^

^Format |PZINFO| 

<--

--> Tiger syntax ^

^Format  |[addr#]PZINFO| 
^Type |Card-Addressed|

<--

''PZINFO'' is a diagnostic command. ASI reserves the right to change the format of the ''PZINFO'' command at any point as more diagnostic features are found to be useful.

--> MicroMirror Example on Tiger ^

<asi> $ 3PZINFO
Hdwr REV.E 
V0 :24.3 V
HV :143.5 V
V1 :63.7 V
V2 :63.2 V
V3 :63.2 V
V4 :64.9 V
V5 :64.3 V
V6 :65.4 V
I2C Check> DAC[OK] OSC1[OK] OSC2[OK] EEPROM[OK]
Mode> A[IN] B[IN] C[IN] D[IN]</asi>

<--

--> Piezo Example on Tiger ^

<asi> $ 1PZINFO
Voltages @ Pos1>
HV   : 147 V
Sout : 4 V
Pzout: 65 V
I2C Check> DAC[OK] SWITCH[OK] DigPot[OK] 
ADEPT Rev 0
DigPot> Sgoffset: 110 Gain: 96 
Closed Loop
TG1000 IN
HV ENABLE 
FAST MODE  
SG Offset [OK]</asi> 

<--

--> Piezo Example on MS2000 ^

<asi> $ PZINFO
Voltages @ Pos1>
HV   : 147 V
Sout : 4 V
Pzout: 65 V
I2C Check> DAC[OK] SWITCH[OK] DigPot[OK] 
ADEPT Rev 0
DigPot> Sgoffset: 110 Gain: 96 
Closed Loop
TG1000 IN
HV ENABLE 
FAST MODE  
SG Offset [OK]</asi> 

<--

--> PMT example on TGPMT ^

if TGPMT card address is 7. 

<asi> $ 7pzinfo
Hdwr REV.0 
V0 :24.0 V
V1 :15.0 V
Avg: 2 
I2C FRAM: OK 
PMT0> Gain:   0 , ADC:   13 , BG:    0 , Status: ENABLED 
PMT1> Gain:   0 , ADC:   13 , BG:    0 , Status: ENABLED 
<LF></asi>

<--
{{tag>commands tiger ms2000 piezo micromirror tgpmt}}